Optimization of the upgrading process of bio-oil from palm fronds: The effect of temperature, catalyst mass ratio, and reaction time
DOI:
https://doi.org/10.24114/jpkim.v16i1.52556Keywords:
Bio-oil, Hydrodeoxygenation, Palm fronds, Upgrading processAbstract
The lignocellulosic component contained in palm frond waste has potential as an alternative fuel by converting it into bio-oil through a pyrolysis process. However, bio-oil has poor quality when compared to conventional fuels. Therefore, the Hydrodeoxygenation (HDO) process has been widely developed as a promising way to improve the poor physicochemical properties of bio-oil. In this study, a bimetallic CuO-ZnO catalyst loaded on mordenite zeolite was used as a catalyst for HDO bio-oil from palm fronds. Optimization efforts were made on several parameters that affect the reaction including temperature, catalyst mass, and reaction time. This study aims to improve the quality of bio-oil and determine the effect of variations in reaction parameters on the physicochemical properties of upgraded bio-oil. The optimum condition found was the HDO process with a catalyst mass of 3.5 wt% at 325 °C for 120 min. The physicochemical properties of bio-oil after the upgrading process were successfully improved from those of raw bio-oil. The result is a decrease in water content and total acid number, an increase in C and H content accompanied by a reduction in oxygen content with a degree of deoxygenation reaching 72.9%, and an increase in higher heating value (HHV).References
Astuti, M. D., Kristina, D., Rodiansono, R., & Mujiyanti, D. R. (2020). One-pot selective conversion of biomass-derived furfural into cyclopentanone/Cyclopentanol over TiO2 supported bimetallic Ni-M (M = Co, Fe) catalysts. Bulletin of Chemical Reaction Engineering & Catalysis, 15(1), 231“241. https://doi.org/10.9767/bcrec.15.1.6307.231-241
Bjelić, A., Grilc, M., HuÅ¡, M., & Likozar, B. (2019). Hydrogenation and hydrodeoxygenation of aromatic lignin monomers over Cu/C, Ni/C, Pd/C, Pt/C, Rh/C and Ru/C catalysts: Mechanisms, reaction micro-kinetic modelling and quantitative structure-activity relationships. Chemical Engineering Journal, 359(July 2018), 305“320. https://doi.org/10.1016/j.cej.2018.11.107
Chantanumat, Y., Phetwarotai, W., Sangthong, S., Palamanit, A., Abu Bakar, M. S., Cheirsilp, B., & Phusunti, N. (2022). Characterization of bio-oil and biochar from slow pyrolysis of oil palm plantation and palm oil mill wastes. Biomass Conversion and Biorefinery, 13(15), 13813“13825. https://doi.org/10.1007/s13399-021-02291-2
Dohade, M., & Dhepe, P. L. (2018). Efficient method for cyclopentanone synthesis from furfural: Understanding the role of solvents and solubility in a bimetallic catalytic system. Catalysis Science and Technology, 8(20), 5259“5269. https://doi.org/10.1039/c8cy01468j
Gea, S., Hutapea, Y. A., Piliang, A. F. R., Pulungan, A. N., Rahayu, R., Layla, J., Tikoalu, A. D., Wijaya, K., & Saputri, W. D. (2022). A comprehensive review of experimental parameters in bio-oil upgrading from pyrolysis of biomass to biofuel through catalytic hydrodeoxygenation. BioEnergy Research, 16(1), 325“347. https://doi.org/10.1007/s12155-022-10438-w
Gea, S., Irvan, I., Wijaya, K., Nadia, A., Pulungan, A. N., Sihombing, J. L., & Rahayu, R. (2022a). Bio-oil hydrodeoxygenation over acid activated-zeolite with different Si/Al ratio. Biofuel Research Journal, 9(2), 1630“1639. https://doi.org/10.18331/brj2022.9.2.4
Gea, S., Irvan, Wijaya, K., Nadia, A., Pulungan, A. N., Sihombing, J. L., & Rahayu. (2022b). Bio-oil hydrodeoxygenation over zeolite-based catalyst: the effect of zeolite activation and nickel loading on product characteristics. International Journal of Energy and Environmental Engineering, 13(2), 541“553. https://doi.org/10.1007/s40095-021-00467-0
Husna, A. F., Febrianti, F., Syah, H. H., Pangaribuan, R. A., Surbakti, T. A., Sihombing, J. L., & Pulungan, A. N. (2022). Conversion of cellulose from palm oil middle waste (Elaeis Guineensis) into bio-oil products as alternative fuel. Egyptian Journal of Chemistry, 65(11), 61“67. https://doi.org/10.21608/ejchem.2022.96526.4517
Kumar, P., Yenumala, S. R., Maity, S. K., & Shee, D. (2014). Kinetics of hydrodeoxygenation of stearic acid using supported nickel catalysts: Effects of supports. Applied Catalysis A: General, 471, 28“38. https://doi.org/10.1016/j.apcata.2013.11.021
Liu, T., Tian, Z., Zhang, W., Luo, B., Lei, L., Wang, C., Liu, J., Shu, R., & Chen, Y. (2023). Selective hydrodeoxygenation of lignin-derived phenols to alkyl cyclohexanols over highly dispersed RuFe bimetallic catalysts. Fuel, 339(100), 126916. https://doi.org/10.1016/j.fuel.2022.126916
Luo, J., Monai, M., Yun, H., Arroyo-RamÃrez, L., Wang, C., Murray, C. B., Fornasiero, P., & Gorte, R. J. (2016). The H2 pressure dependence of hydrodeoxygenation selectivities for furfural over Pt/C catalysts. Catalysis Letters, 146(4), 711“717. https://doi.org/10.1007/s10562-016-1705-x
Madsen, A. T., Ahmed, E. H., Christensen, C. H., Fehrmann, R., & Riisager, A. (2011). Hydrodeoxygenation of waste fat for diesel production: Study on model feed with Pt/alumina catalyst. Fuel, 90(11), 3433“3438. https://doi.org/10.1016/j.fuel.2011.06.005
Pulungan, A. N., Goei, R., Harahap, F., Simatupang, L., Suriani, C., Gea, S., Hasibuan, M. I., Sihombing, J. L., & Tok, A. I. Y. (2023). Pyrolysis of palm fronds waste into bio-oil and upgrading process via esterification-hydrodeoxygenation using Cu“Zn metal oxide catalyst loaded on mordenite zeolite. Waste and Biomass Valorization, 15(1), 187“206. https://doi.org/10.1007/s12649-023-02153-0
Pulungan, A. N., Goei, R., Kembaren, A., Nurfajriani, N., Sihombing, J. L., Gea, S., Wong, H. R., Hasibuan, M. I., Rahayu, R., & Tok, A. I. Y. (2023). Two stages upgrading of bio-oil through esterification and hydrodeoxygenation reactions using Fe2O3-CoO supported catalyst. Biomass Conversion and Biorefinery, 0123456789. https://doi.org/10.1007/s13399-023-04237-2
Ramos, R., TiÅ¡ler, Z., Kikhtyanin, O., & KubiÄka, D. (2016). Towards understanding the hydrodeoxygenation pathways of furfural-acetone aldol condensation products over supported Pt catalysts. Catalysis Science and Technology, 6(6), 1829“1841. https://doi.org/10.1039/c5cy01422k
Remón, J., Casales, M., Gracia, J., Callén, M. S., Pinilla, J. L., & Suelves, I. (2021). Sustainable production of liquid biofuels and value-added platform chemicals by hydrodeoxygenation of lignocellulosic bio-oil over a carbon“neutral Mo2C/CNF catalyst. Chemical Engineering Journal, 405, 126705. https://doi.org/10.1016/j.cej.2020.126705
Shao, Y., Sun, K., Fan, M., Gao, G., Wang, J., Zhang, L., Zhang, S., & Hu, X. (2022). Synthesis of a thermally and hydrothermally stable copper-based catalyst via alloying of Cu with Ni and Zn for catalyzing conversion of furfural into cyclopentanone. ACS Sustainable Chemistry & Engineering, 10(27), 8763“8777. https://doi.org/10.1021/acssuschemeng.2c01082
Sihombing, J. L., Herlinawati, H., Pulungan, A. N., Simatupang, L., Rahayu, R., & Wibowo, A. A. (2023). Effective hydrodeoxygenation bio-oil via natural zeolite supported transition metal oxide catalyst. Arabian Journal of Chemistry, 16(6), 104707. https://doi.org/10.1016/j.arabjc.2023.104707
Sondakh, R. C., Hambali, E., & Indrasti, N. S. (2019). Improving characteristic of bio-oil by esterification method. IOP Conference Series: Earth and Environmental Science, 230, 012071. https://doi.org/10.1088/1755-1315/230/1/012071
Song, W., Liu, Y., Baráth, E., Zhao, C., & Lercher, J. A. (2015). Synergistic effects of Ni and acid sites for hydrogenation and C-O bond cleavage of substituted phenols. Green Chemistry, 17(2), 1204“1218. https://doi.org/10.1039/c4gc01798f
Tian, H., Gao, G., Xu, Q., Gao, Z., Zhang, S., Hu, G., Xu, L., & Hu, X. (2021). Facilitating selective conversion of furfural to cyclopentanone via reducing availability of metallic nickel sites. Molecular Catalysis, 510(March), 111697. https://doi.org/10.1016/j.mcat.2021.111697
Wang, C., Luo, J., Liao, V., Lee, J. D., Onn, T. M., Murray, C. B., & Gorte, R. J. (2018). A comparison of furfural hydrodeoxygenation over Pt-Co and Ni-Fe catalysts at high and low H2 pressures. Catalysis Today, 302, 73“79. https://doi.org/10.1016/j.cattod.2017.06.042
Zhong, M., Huang, J., Yuan, J., Rong, S., Ou, P., Chen, X., Zhang, B., Ke, Q., & Zhu, Z. (2021). Solvothermal synthesis and characterization of porous co microspheres. Materiali in Tehnologije, 55(5), 663“666. https://doi.org/10.17222/MIT.2021.160
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Junifa Layla Sihombing

This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors published in this journal agree to the following terms:
- The copyright of each article is retained by the author (s).
- The author grants the journal the first publication rights with the work simultaneously licensed under the Creative Commons Attribution License, allowing others to share the work with an acknowledgment of authorship and the initial publication in this journal.
- Authors may enter into separate additional contractual agreements for the non-exclusive distribution of published journal versions of the work (for example, posting them to institutional repositories or publishing them in a book), with acknowledgment of their initial publication in this journal.
- Authors are permitted and encouraged to post their work online (For example in the Institutional Repository or on their website) before and during the submission process, as this can lead to productive exchanges, as well as earlier and larger citations of published work.
Jurnal Pendidikan Kimia is licensed under a Creative Commons Attribution 4.0 International License